RIVIT 4035700, Инструкция по эксплуатации, Страница: 7 / 13

20 | 40
EN
REV | 02
RIV 503
SAFETY MEASURES
• Use the riveting tool properly and for the purposes for which it has been manufactured.
• Any kind of modifi cation made on the riveting tool and its equipment by the customer itself, will be
done under the fully responsibility of the customer. In this case, Rivit srl declines any responsibility.
• The riveting tool must be always kept in safety conditions and must be revised at regulkar intervals
by expert and authorized workers, following the maintenance producers of Rivit srl.
• The riveting tool will always be used following the EC normative "on health and safety measures
on job" (Directive 2006/42/EC). Any problem or information regarding the correct operating of the
tool, will have to be returned to Rivit srl.
• The safety measures to be observed during the use of the riveting tool, must be explained from
the customer to all users. Always detach the air feeding from the take-off point of the toll before
regulating, repairing and cleaning operations.
• Dont'use the tool if is turned towards other persons.
• Operating pressure have not to exceed 7 bar - 100 LBF/IN 2 .
• Make sure that the air discharges are not blocked or covered and the feeding hoses are always in
good working conditions.
• The operations of maintenance, repairing and cleaning must be done when the tool is not fed.
• When using the riveting tool, wear protective glasses or visors and gloves.
• Use only original spare parts for repairing and maintenance. Rivit srl declines any responsibility
for any kind of damages caused by not observing the above and following instrucions (directive
CEE 85/734).
• If the noise level is over the safety limit of 85 dB (A), use the proper hearing protections (antinoise
headset etc.).
OPERATING INSTRUCTIONS
Air feed
All the tools works with compressed air, with a pressure of 6 bar.
We suggest to use regulators of pressure and automatic fi ltering systems on the main net of feeding air.
These will have to stay to 3 meters of distance from the tool (see the drawing), in order to assure an
optimal pressure in the tool and its maximum duration-life with a minimum maintenance.
The fl exible tubes for the air compressed in entrance must be in a position to supporting a pressure
of 10 bars and will have to be resistant to the oil, covered of a material resistant to the abrasions and
protected in case bad job conditions could damage them.
All the fl exible tubes for the compressed air must have a diameter of minimum passage of 6,4 mm or
1
/
4
of inch.
The pressure regulator must be set up to 6,5 bars in consideration of the pressure fall.