- 27 -
4.2.7
Reducing pipes
We provide suitable reducing pipes for rivets with a mandrel diameter smaller than 3.2
mm for RBx-15 or smaller than 4.0 mm for RBx-20. Reducing pipes reduce the diameter of
the guide tube through the tool and thereby prevent the remaining rivet mandrel from
jamming in the guide tube.
Tool type
Tool guide tube
Reducer
Reducing pipe
Item number
Reducing pipe
RK-777C-1Q
5.0 mm
2.4 mm
040013001
RK-777C-1Q
5.0 mm
3.4 mm
040012002
RK-777C-1STR
6.3 mm
2.4 mm
040013001
RK-777C-1STR
6.3 mm
3.4 mm
040013002
4.2.8
Selection of nose piece
You can use the riveting tool for processing different size rivets. When doing so, note the
exact specification of the rivet and adjust the nose piece and reducing pipe, if necessary
(chapter 4.2.7 von page 27).
The maximum riveting mandrel diameter is ø 1.5 - 4.5 mm for
RK-777C-1Q
and 1.5
–
4.5 mm
for
RK-777C-1STR
, with special traction heads diameters of > 4.5 mm are also possible.
Measure the diameter of the riveting mandrel and select the next largest nose piece.
e.g. riveting mandrel diameter 2.7 mm / mouthpiece RK777-NP32 (3.2 mm max. riveting
mandrel di reducing pipe 040013002). The minimum mandrel length for standard
nose pieces is 30 mm and for security nose pieces 35 mm.
WARNING
Risk of injury due to use of incorrect rivets
Using rivets with the incorrect mandrel diameter can lead to significant
damage to the tool and cause injuries
•
Do not use a rivet with a mandrel diameter below 3.2 mm (RK-777C-1Q) or
4.0 mm (RK-777C-1STR) without a reducing pipe.