Riverstone Networks RS 3000, Руководство по началу работы

Страница: 58 / 103

3-8 Riverstone Networks RS 3000 Switch Router Getting Started Guide
Installing the Hardware Hardware Installation
2. Gently insert the GBIC module into the GBIC slot opening. The GBIC door on the line card folds
in, and the internal guides engage the alignment slots on the sides of the GBIC module.
Warning
If the GBIC module does not go in easily, do not force it. If the GBIC is not
oriented properly, it will stop about one quarter of the way into the slot and
should not be forced any further. Remove and reorient the GBIC module so
that it slides easily into the slot.
3.
Push the GBIC module in until the connector engages the 20-pin port. The GBIC is now installed.
3.3.4 Installing the ATM PHY Cards
Each ATM line card has two slots available for PHY cards. One ATM PHY card can be installed into each available
slot. You will need a #2 Phillips screwdriver to perform this procedure.
Figure 3-9 shows an example of how to install a PHY card. The procedure following the figure describes how to do
this.
Figure 3-9 Installing an ATM PHY card
ATM Board
Seat screws into
mounting holes,
then press PHY card
to fully engage connector
Phy Card
Guide Rails