Page 4 of 7
Oakmont
Bedroom
Assembly Instructions
Made in Viet Nam
email: [email protected]
FURNITURE
Riverside
To remove the drawer:
A. Pull the drawer fully open so the black latch is visible in the inside
channel of the guides.
B. Release the latches by simultaneously pushing one lever up and the
other down.
C. At the same time, pulling the drawer forward until the slides release.
Note which opening they are removed from so they can be reinstalled
back into the correct opening.
ASSEMBLY STEPS :
1. Remove both drawers from the Storage Footboard. Refer to the steps above.
2. Place the Storage Footboard Frame (F-A) face down on a clean and soft surface.
3. Attach the Footboard Bun feet (F-B) to the bottom of the Footboard.
4. Attach the Drawer Box Support Legs (F-D) using the Flat Washers (F-I), Spring Washers
(F-H) and Bolts (F-G). Tighten with the Allen Wrench (F-J).
After the Bed has been completely assembled, reinstall the drawers back into the opening from
where they were removed by aligning the channels and gently pushing the drawer back
into the footboard. Open and close a couple times to verify they are working properly.
