F-C
F-B
F-D
F-C
F-B
Made in Viet Nam
Riverside
FURNITURE
email: [email protected]
Page 4 of 10
R-B
R-C
ASSEMBLY STEPS :
To prevent possible damage to furniture
and personal injury, it is recommended
that two people are used to perform the
following steps.
7. Carefully position one end of one Bed
Rail (R-A) onto the All-Thread Bolts on
the Headboard and connect with the
Arc Washers & Nuts (R1). Only
partially tighten the Nuts until the
Footboard has been connected. Repeat
for the other Bed Rail.
8. Position and connect the Footboard
(F-A) to the other end of the Bed Rails,
as in the previous Steps.
9. Carefully align the Footboard to be
'square' with the Headboard. Using the
12mm Open Wrench (R4) tighten all
Bolts attaching the Side Rails to the
Headboard and Footboard. (See Detail
E).
10. Attach the four Lower Support Legs
(F-B) to the bottom of the Upper
Support Legs (F-C) and then to the two
Slat Center Supports (F-D). (See Detail
F). Position in middle of Bed from Head
to Foot.
11. Unroll and spread the Roll Slats to the
Bed Rails and Slat Center Support (F-D).
Attach the Slats to the Bed Rails and Slat
Center Supports using the Wood Screws
(F1) and your Phillips Screwdriver. (See
Detail G).
The levelers located at the bottom of the
Support Legs can be adjusted if
necessary to support the Slats.
End View of Rail
Slats
Slats
F1
Modern Gathering
Panel King Standard Bed
Assembly Instructions
