Riverlea Duratuf Garrison Sheds PS62, Руководство по сборке

Страница: 11 / 16

ASSEMBLE FRONT PANEL
10
SELECT:
1 x 1.890 2 Pan Wall Sheet
1 x 1.890 1 Pan Wall Sheet
1 x 2.020 Top Plate (Red)
1 x 2.020 Bottom Plate (Green)
2 x 1.890 Door Jamb Flashings
16 x 30mm Galv Clouts
8 x Rivets
STEP 1:
•
Lay out 1 x Top Plate and 1 x Bottom Plate on a flat surface
as shown.
STEP 3:
•
Place 2 x Wall Sheets on timber, ensuring wall sheets fit un-
derneath door jamb flashings.
•
Ensure that the top of the sheet is flush with the top of the
Top Plate and that the sides of the wall sheets overhang the
Top Plate by
15mm as shown. Nail wall sheets to Top Plate
(two clouts per pan)
•
Nail the wall sheets to the Bottom Plate making sure that the
Plates are the correct distance apart and that the sides of the
wall sheet overhang the Bottom Plate by
15mm .
•
Drill & rivet Door Jamb Flashings to wall sheets using four
rivets equally spaced on each side.
IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER
BASE PLATE –READ THE FOLLOWING;
For sheds with Raised Base Plate option only (see page 6), deduct
30mm from measurement shown between Top and Bottom Plates on
all wall panels, so cladding protrudes 20mm below bottom plate
.
15mm
15mm
15mm
15mm
TOP
PLATE
DOOR
JAMB
NAIL
STEP 2:
•
Using 2 x 30mm clouts, nail the Door Jamb Flashing flush
with the top of the Top Plate at the correct measurement as
shown in plan view. Pre drill holes using a 3.5mm drill bit.
•
Check the distance between the top and bottom plates then
use a further 2 x 30mm clouts to nail the Door Jamb Flash-
ings to the bottom Plate. Pre drill holes.
NOTE:
The Doorway is offset - closer to L/H end but these
measurements can be swapped so that doorway is
closer to R/H end.
203mm
1450mm
TOP PLATE
DOOR OPENING
Plan View
367mm
BOTTOM PLATE
1859mm
TOP PLATE
1859mm