Riverbed SteelCentral AppResponse 2180, Руководство по модернизации и обслуживанию

Страница: 69 / 82

Reference: Appliance Specifications | 69
Interceptor 9600 specifications
Port locations, LEDs, and buttons
This figure illustrates the front of the appliance, including LEDs and buttons.
Figure A-9. IC 9600 front panel
This table summarizes the appliance LEDs and buttons on the Interceptor 9600 appliance.
Reference LED/button Description
1 System ID Button with
Integrated LED
Maintenance = Blue
Toggles the integrated ID LED and the blue server board ID LED on
and off. The System ID LED identifies the system for maintenance
when installed in a rack of similar server systems. You can also
remotely turn on and turn off the System ID LED using the Intelligent
Platform Management Interface (IPMI)
ipmitool chassis identify
command, which causes the LED to blink for 15 seconds.
A duplicate System ID LED is on the back of the appliance to the left
of the video port.
2 NMI Button
Pressing the NMI button puts the appliance in a halt state and issues a
nonmaskable interrupt (NMI). This helps when performing diagnostics
for a given issue where a memory download is necessary to
determine the cause of the problem. To prevent an inadvertent
system halt, the NMI button is located behind the Front Control Panel
faceplate and is only accessible with the use of a small-tipped tool
such as a pin or paper clip.
3
10
Network Activity LED
Primary
Auxiliary
Link = Green
Activity = Blinks green. The blink rate is consistent with the amount of
network activity.
The appliance doesn’t use the LEDs 4 and 9 shown in Figure A-5 .