MODEL NO.: 20187/20188
8
6.
Flush Mount Assembly
NOTE: If assembling with down rod, proceed to Step 7
1.
Remove ground wire along with the screw and washer
from the mounting plate
2.
Remove four (4) screws and spring washers from upper
motor housing
3.
Attach canopy to upper motor housing with same screws
and washers removed in Step 2
WARNING
–
Ensure screws are firmly
secured
4.
Hang fan on mounting plate hook through canopy mount
hole for easy hands-free electrical wiring
7.
Assembly with Down Rod
1.
Remove pin and clip from down rod. Slide the down rod
through the canopy and the down rod cover as shown in
figure
2.
Thread the electrical wires through the down rod and pull
the extra wire slack through the down rod
Tip: Apply a small piece of electrical tape to the ends of the
electrical wires to keep them together when threading them
through the down rod
3.
Loosen the yoke set screw. Place the down rod into the
motor housing yoke and re-insert the previously removed
pin and clip. Tighten yoke screw securely
4.
With the hanging bracket fully secured to the outlet box,
you are now ready to hang your fan. Grab the fan securely
with two (2) hands. Place the down rod ball into the
hanging bracket and rotate until the ball sits securely in
the hanging bracket tab
