13
FUEL COCK/ FUEL VALVE
The fuel cock/valve supplies fuel from the tank to the carburetor.
The fuel cock/valve lever positions are explained as follows and shown in the illustrations.
FUEL OFF
Arrow mark positioned over “OFF” position. Fuel is off and fuel will not flow to the carburetor. Always turn the
fuel valve to the ‘OFF’ position and allow the engine to idle until it burns remaining fuel in the line when the ATV
is being stored. Once the fuel in the line has been cleared, drain the carburetor bowls. Following this procedure
will help reduce corrosion and carburetor damage.
FUEL ON
Arrow mark positioned over “On” position. Fuel is on and fuel will flow to the carburetor.
SEAT
To remove the seat, pull the seat lock lever backward and then pull up the seat. The seat lock is located under
the seat in the back of the ATV.
TO INSTALL SEAT
Insert the tabs on the front of the seat into the seat holders and push down on the seat at the rear. Make sure
that the seat is securely installed in place and will not move during operation.
ADJUSTING SUSPENSION SPRING PRELOAD
This ATV is equipped with 3 adjustable coil springs. The spring preload can be adjusted to suit the rider’s weight
and the riding conditions. Turn the spring preload adjusting ring to increase (stiffest= 5) or decrease (softest= 1)
the spring preload. Increased spring tension will stiffen the ride. Decreasing spring tension will soften the ride.
The suspension was pre-set at the factory, but can be adjusted with a special
suspension adjustment tool available for purchase at your Rival Motorsports dealer.
NOTICE
Содержание Mudhawk 6
Страница 24: ...20 GETTING TO KNOW YOUR ATV ...