RC Series
RC4602SV-7416A-30 Installation Guide
04-2017-A
www.rivatech.de
8
4. INSTALLATION
4.1. Installing the camera
Installation without bracket
LAN cable
Power cable
Audio cable
DI/DO cable
1)
Loosen the three screws on the top of the
camera, and detach the safety ring from the top.
2)
Twist the top of the camera counter-clockwise to
separate it from the main body, and push the lever
of the plastic cover at the bottom of the top
outward to open it. Then, insert the provided
terminal blocks to the corresponding places on the
PCB by reference to the image on the previous
page.
3)
Drop all the necessary cables through the neck of
the camera’s top, and fix the top to your installed
bracket or on the designated spot.
4)
Install the provided ferrite cores on the cables by
winding cables around the ferrite cores once. Refer
to the image on the left.
5)
Connect all the cables to corresponding
connectors by reference to the image on the
previous page. Then, close the PCB on the top of the
camera.
6)
Hook the safety ring to the top of the camera
while carefully holding the camera's main body, and
align the triangle marks on the top with the main
body.
7)
Twist the main body counter-clockwise once the
camera’s top and the main body are properly
aligned, and tighten the three screws on the top.
Caution
!
Install the device after removing the bubble wrap inside the dome cover.