RS16141 Rev. 2/8/2016 BR
-
INSTALLATION INSTRUCTIONS
-
Press the (2) locking tabs (A) on the coolant reservoir to-
wards the reservoir body and lift the reservoir out of its
mounting location. Lay the reservoir to the starboard side
to provide better access to the exhaust.
Remove (6) bolts (B), nuts and washers holding rear grab
rail in place and remove grab rail. Caution: Do not drop
nuts and washers into hull. (Figure 4)
Figure 4
RXT
-
X/RXT/GTX
-
SC
:
Remove two bolts holding coolant reservoir to deck beam
(A). Pull out on retaining tabs (B) and lower the coolant
reservoir away from its mounting location. Lay the reser-
voir to the starboard side to provide better access to the
exhaust.
Remove 4 deck beam bolts and 2 grab rail bolts (C), nuts
and washers. Caution: Do not drop nuts and washers into
hull. Remove deck beam and grab rail assembly. (Figure
5)
Figure 5
Remove or open seat.
RXP
-
X
:
Remove the two bolts on each side holding the side panels
in place and remove the side panels. (Figure 1)
Figure 1
Remove 2 screws (A) and 2 plastic rivets (B) holding vent
cover to rear grab handle and remove vent cover (Figure
2).
Figure 2
Remove 2 plastic rivets under side panels removed previ-
ously (Figure 3)
Figure 3
