9
mountIng brEad bIn lId
fastEnIngs
•
Place the bread bin (1) into the (inserted)
drawer.
•
Shorten the supporting pipe (3) to the
correct length (inner carcass width minus
8 mm).
•
If necessary, route the supporting pipe
into the lid rack (6).
•
Align the supporting pipe parallel to the
bread bin lid (2) at a distance of 16 mm
(Figure D).
•
Place the bread bin lid onto the bread bin:
– The "ritter" emblem should be visible at
the front.
– The bread bin lid should contact the
front of the drawer
figure d:
•
Pull the drawer out far enough, so that
the supporting pipe makes contact with
the front edge of the carcass side.
•
Mark the upper edge of the supporting
pipe on the left and right of the inside of
the carcass.
•
Remove the bread bin lid and the bread
bin.
•
Remove the drawer.
figure E:
•
Use the drill template and a centre punch
to mark the following on the right-hand of
the carcass interior:
– the holes for the right retaining
bracket (10)
– the holes for the lid carrier (11)
figure f:
•
Use the drill template and a centre punch
to mark the holes for the left retaining
bracket (10) on the left of the carcass
interior.
•
Drill the marked holes (Ø4.5 mm x 10 mm).
InstallIng VEntIlatIon bEzEl
•
Drill the hole for the ventilation bezel (7)
(Ø44 mm):
–
on the rear side of the carcass
–
in the centre, level with the bread bin
•
Insert the ventilation bezel.
fInalIsatIon
•
Insert the retaining brackets (10) into the
bores and fasten them in place using the
fastening screws (13).
•
Insert the bread bin lid (2) with the sup-
porting pipe (3) into the retaining brack-
ets.
•
Mount the lid carrier (11) using the fasten-
ing screw (14).
•
Insert the drawer.
•
Place the bread bin into the drawer.
•
Check the position of the lid carrier:
–
The lid carrier fits flush to the front of
the bread bin
– The lid carrier must not contact the side
of the bread bin when the drawer is
pulled out
•
If necessary, adjust the position of the lid
carrier (6).
•
Tighten all screws.
English
