Rittal 7338.321, Монтаж, установка и эксплуатация

Страница: 56 / 86

9.2 Homepage
Fig. 41: Maintenance program homepage
The following options are shown after starting the maintenance program:
● Project (Fig. 41 /1)
Ä Chapter 9.3 „Project” on page 57
– Import data (Fig. 41 /2) (gray background, if no system is connected)
– Transfer data (Fig. 41 /3) (gray background, if no data has been imported yet)
– New project (Fig. 41 /4)
– Open project (Fig. 41 /5)
– Save project (Fig. 41 /6) (gray background, if no project was opened previ-
ously)
– Save project as (Fig. 41 /7)
● Event memory (Fig. 41 /14)
Ä
Chapter 9.4 „Event memory” on page 57
● Firmware (Fig. 41 /13)
Ä
Chapter 9.5 „Firmware” on page 58
● Customer data (Fig. 41 /12)
Ä
Chapter 9.6 „Customer data” on page 58
● Operation (Fig. 41 /11)
Ä
Chapter 9.7 „Operation” on page 60
The following information is displayed:
● Network Interface Card serial number, Network Interface Card version number
(Fig. 41 /8)
● Firmware version (Fig. 41 /9)
The following input option exists:
● The project can be described in the project description (Fig. 41 /10).
This description is saved with the project via "Save project as" or via "Save
project" with the data on the PC . The project description is not transferred to the
system (DET-AC III Slave) and it is not saved in the system. The project descrip-
tion is not available after the data has been exported from a system.
Maintenance program
Operating Instructions / DET-AC III Slave / 916007 / 05-2016 / en_US 56