4
Assembly and installation
Automatic Door Control Unit
5
EN
4.2
Installation
Warning!
The system operates only with safety
extra-low voltage.
Under no circumstances may voltages
higher than those prescribed be
connected to the system. Lethal
danger!
4.3
Installation procedure
Once all system components have been installed in
accordance with the associated installation
instructions, the installation as described below is
performed.
Note!
For the installation, the system must
remain disconnected from the power
supply for the complete time.
Otherwise defects can occur to the
unit.
4.3.1
Automatic Door Control Unit wiring
Note!
The maximum signal cable length of
6 m must not be exceeded.
Connection of the Automatic Door Control Unit to the
CMC-TC I/O unit.
Connect the inputs from Door 1/2 and Door 3/4 with
any free port of the CMC-TC I/O unit as shown in
Fig. 5. Use the provided RJ12 cable for this purpose.
Door 1/2 to Port 1; Door 3/4 to Port 2
Connection of the Automatic Door Control Unit to a
Basic CMC or an LCP Plus Control Unit
Connect the inputs from Door 1/2 and Door 3/4 with
any free port on the Basic CMC as shown in Fig. 6.
Use the RJ12 cable provided for this purpose.
Door 1/2 to Port 1
Door 3/4 to Port 2
Connection of the Automatic Door Kits
As many as three holding magnets can be connected
to the Door 1-4 outputs.
Connect the Automatic Door Kits as shown in Fig. 7.
Door 1: Rack 1 front door
Door 2: Rack 1 rear door
Door 3: Rack 2 front door
Door 4: Rack 2 rear door
7320.210
I/O
1 2 3 4
Fig. 5: Connection to the CMC-TC I/O unit
7320.110
P-I
2
C
Fig. 6: Automatic Door Control Unit with Basic CMC
Fig. 7: Connection of the holding magnets of the Automatic Door
Kits
