Page 18
For assistance, call RITRON at 800-872-1872, or go to www.ritron.com
10. SETTING BATTERY SAVER
OPTIONS
TO SET BATTERY SAVER OPTIONS:
The Battery Saver factory default is "Battery Saver enabled."
In this setting, which greatly extends battery life, Quick Talk
checks switch inputs for changes 4 times a second.
a. Dial
"932"
to enable Battery Saver.
NOTE:
DO NOT disable the Battery Saver unless you
need to detect very fast changes in the switch
inputs.
To detect very fast changes, set Quick Talk to check switch
inputs rapidly:
b. Dial
"931"
to disable Battery Saver.
NOTE:
Powering the Quick Talk with an external Power
Supply is very practical with the Battery Saver
Option disabled, because Quick Talk draws
approximately 7 mA continuously with this setting.
9.
ENABLE/ DISABLE
STATUS MESSAGES
TO DISABLE LOW BATTERY MESSAGE:
a. Pick up the telephone receiver and listen for the
acknowledge tone.
b. Dial
"941"
.
TO ENABLE LOW BATTERY MESSAGE:
a. Pick up the telephone receiver and listen for the
acknowledge tone.
b. Dial
"942"
.
NOTE: The default is Low Battery Message On.
TO DISABLE EXTERNAL POWER FAILURE MESSAGE:
a. Pick up the telephone receiver and listen for the
acknowledge tone.
b. Dial
"951"
.
TO ENABLE EXTERNAL POWER FAILURE MESSAGE:
a. Pick up the telephone receiver and listen for the
acknowledge tone.
b. Dial
"952"
.
NOTE: The default is Power Failure Message
Off.
8.
RECORDING UNIQUE
POWER FAILURE MESSAGES
What is the purpose of recording a unique Voice
Phrase for the Power Failure Message?
When it senses
power failure, Quick Talk transmits a factory-programmed
"Power Failure" message no more often than once an hour.
If you have several units grouped within radio range of one
another, we recommend you customize messages to easily
identify the specific unit.
NOTE:
Also physically mark the Quick Talk case with the
same unique identifier (number) you record for
Quick Talk location phrasing (see page 13).
Do I need to program this feature?
If you use only one
Quick Talk in an area, or if you regularly change Quick Talk
batteries, the factory-programmed message may be
sufficient: you can skip to the next section.
TO RECORD POWER FAILURE PHRASE
:
a. Pick up the telephone receiver and listen for the
acknowledge tone.
b. Dial
"34"
Quick Talk prompts you with three short
tones to begin speaking.
NOTE:
Your recorded POWER FAIL phrase is to be
no longer than 1.5 seconds.
EXAMPLE:
"
Power fail five
c. Hang up the telephone
when you are done speaking.
d. To review the POWER FAIL phrase, dial
"44"
.
e. Repeat steps "a" through "d" until you are pleased with
the results.
Q
UICK
T
ALK
A
DVANCED
F
EATURES
All manuals and user guides at all-guides.com
