Publication No. 14520009
LMH-100 Installation Instructions
Page 3
IMPORTANT
The Loudmouth power and speakers cables can be routed from the LMH-100 enclosure in a variety of ways, depending on
the specific installation. Steps 6 through 8 describe the installation of the weatherproof strain relief that was included with
the LMH-100.
An alternative method is to install electrical conduit. Carefully consider your installation before drilling holes in the LMH-100
housing. Be sure there will not be interference with the internal parts, and that the cable and connectors can be routed
through the conduit to the connectors on the bottom of the Loudmouth receiver.
Step 6:
Drill LMH-100 Enclosure
for Strain Relief (Optional)
A hole can be drilled in the bottom of the LMH-100
enclosure to route the Loudmouth power and speaker
cables. The instructions in this manual describe the
installation of the weatherproof strain relief
(25204500, 25204600) and plug (25204700) included
with the LMH-100.
1. Carefully measure and mark the location
of the hole on the bottom of the LMH-
100 enclosure per the diagram at right.
2. Drill a .875 (7/8) hole in the bottom of the LMH-
100 enclosure. Remove all residual plastic after
drilling and thoroughly clean the area.
.875” (7/8)
5.046”
1.00”
WARNING
: The location of this hole is critical to the
successful routing of the power and speaker cables
and cannot be compromised.
L
o
u
d
M
o
u
t
h
L
o
u
d
M
o
u
t
h
3
2
1
Step 7:
Install Weatherproof
Strain Relief (Optional)
1. Remove clinching nut from strain relief
(25204500)
2. Insert strain relief (25204500) fully through
the hole in the LMH-100 enclosure
3. Secure strain relief (25204500) to the LMH-
100 enclosure with the strain relief nut
(25204600)
