Ritenergy International Air-485, Руководство пользователя

Страница: 5 / 10

Setup
DIP Switch Settings
There are two sets of DIP switches which must be set.
Figure 1
SWITCH POSITION OPERATION
1
DOWN SETS MODE TO MASTER
UP SETS MODE TO SLAVE
2
3
DOWN
LOW
DOWN
POWER
UP
MEDIUM
LOW
DOWN POWER
DOWN MEDIUM
UP
POWER
UP HIGH
UP POWER
4
DOWN NORTH AMERICA
UP AUSTRALIA
5
DOWN 9,600 BAUD (hardwired)
UP 38,400 BAUD (hardwired)
6 MUST BE DOWN
7
DOWN NORMAL MODE
UP SIGNAL STRENGTH TEST
8 MUST BE DOWN
1) NOTE: Any time DIP switch settings are changed, the RESET switch must be pressed.
2) LINK LED (Figure 1)
– For a Master unit, if this LED is on SOLID, it indicates that the
unit is successfully connected to at least one Slave. For a Slave unit, this LED indicates
that it is successfully connected to a Master.
3) TX\RX LEDs (Figure 1)
– These LEDS indicate the transmission and receipt of data.
What a surprise!