RITE-HITE DOK-LOK RHR-600, Руководство пользователя

Страница: 8 / 36

8
RITE-HITE RHR-600 DOK-LOK Owner’s Manual
Install roller track plate onto dock face at specified location by
welding to an embedded steel plate or by using the 15 concrete
anchors provided in conjunction with welding to pit steel and a
leveler frame. Refer to
Figure 5
.
NOTE : Trim roller track plate, as necessary, up to a
maximum of 5" from the bottom. Refer to
RITE-HITE Application Guidelines .
NOTE : Some mechanical dock levelers have an adjusting
nut access hole in the leveler front subframe. If the
RHR-600
DOK-LOK vehicle restraint roller track
interferes with the access hole, the track plate must
be cut to allow access. Refer to
Figure 8, page 9 .
NOTE : Some levelers may be slightly recessed within pit. A
shim must be inserted between the roller track plate
and the leveler front subframe and then must be
welded in place. Refer to
Figure 9, page 9 for
adding a necessary lip guide.
Anchor Installation Instructions
1. Put roller track plate in place.
2. Drill hole of 5/8" diameter and minimum of 4-5/8" deep.
Clean out hole.
3. Insert anchor and drive flush with roller track plate,
making certain that the threaded wedge is put in first. Do
not disassemble anchor prior to installation.
4. Install all anchors and torque to 100 ft-lbs.
NOTE 1 For site specific installation refer to RITE-HITE
Application information provided with DOK-LOK
vehicle restraint. When in doubt, call RITE-HITE
Representative or RITE-HITE Customer Service
at (800) 456-0600.
• A plumb roller track plate is required. If the dock face
is not plumb/perpendicular, contact your RITE-HITE
representative or RITE-HITE at (800) 456-0600.
• The carriage roller track cannot be bent or deformed.
Straighten or replace as required.
IMPORTANT
Fifteen (15) concrete anchors are provided with each
vehicle restraint. You must install an anchor in each
roller track plate hole except those plug-welded to
embedded steel
Figure 5 : Anchoring Roller Track Plate
IMPORTANT
See NOTE 1.