2
Image upon request
Taking a snapshot from the PIR Camera can be initiated by using SMS command from any remote phone
SMS Message structure: [PIN Code][V][Camera No 01-32], example: 1234V01
Images can also be taken using web/smartphone apps (on panels supporting these applications).
Event Report
Every event detected by the PIR camera is recorded into the camera’s memory. The event record consists of the date and time mark, detail description of the event including its source
and a video record.
LED Status
On:
Alarm
Blinking twice:
(In alarm mode) Low battery
Blinking four times:
(In initial learning mode) Successful write operation
Diagnostics
You can perform diagnostic tests on your detector using the Agility keypad or the Agility configuration software. Diagnostics includes testing the detector battery status and the
communication between the detector and the panel. For additional information refer to the
Agility Installer Manual
.
To replace the batteries:
A low battery condition is detected by a flashing LED on each transmission.
To replace the batteries
:
1.
Remove the detector from the mounting bracket.(Figure 2)
2.
Open the battery cover.(Figure 3)
3.
Replace the batteries. Pay attention to the right polarity.
4.
Close the battery cover.
CAUTION:
Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to local regulations.
NOTE
:
After replacing the batteries and closing the tamper, the detector will automatically go into in Walk Test mode for 20 minutes.
Specifications
Electrical
Battery Type:
2 x CR 123, 3V Lithium Battery
Battery Life:
3 year typical lifetime
Current Consumption:
58
μ
A standby;
200 mA max. peak at capture with flash
M
odulation
:
AS
K
RF transmitting
frequencies:
Keep alive time
433.92 MHz; 916 MHz for model
RWX95CM
and
RWX95CM
P
.
Fixed in
20 minutes
Optical
Filtering:
White Light Protection
Pet friendly:
Up to a 36 kg (80lb) animal (pet model)
Physical
Size:
132 x 67,5 x 56 mm
(5.1 x 2.6 x 2.2 in)
Weight:
169 grams (5.96 oz.)
Environmental
RF Immunity:
According to EN50130-4
Operating Temperature:
-10
°
C a 55
°
C
(14
°
F a 140
°
F)
Storage Temperature:
-20
°
C a 60
°
C
(-4
°
F a 140
°
F)
Camera
Type:
CMOS digital image sensor
Lux:
0 Lux (total darkness)
View Angle:
H 90
o
V 71
o
Approvals
EN50131-1,
EN50131-2-2 Grade 2,
EN50130-5 Environmental Class II,
EN50131-6: Type C
Ordering Information
Part Number
Description
RWT95
043300
A
433.92 MHz 2-Way WL PIR Detector
RWT
P
95
043300
A
433.92 MHz 2-Way WL PIR
Pet
Detector
RWX95CM4000A
433.92 MHz 2-Way WL PIR & CAM Detector
RWX95CMP400A
433.92 MHz 2-Way WL PIR Pet & CAM Det.
RISCO Group Limited Warranty
RISCO Group and its subsidiaries and affiliates ("Seller") warrants its products to be free from defects in materials and workmanship
under normal use for 24 months from the date of production. Because Seller does not install or connect the product and because the
product may be used in conjunction with products not manufactured by the Seller, Seller cannot guarantee the performance of the
security system which uses this product.
Seller's obligation and liability under this warranty is expressly limited to repairing and replacing, at Seller's option, within a reasonable
time after the date of delivery, any product not meeting the specifications. Seller makes no other warranty, expressed or implied, and
makes no warranty of merchantability or of fitness for any particular purpose.
In no case shall seller be liable for any consequential or incidental damages for breach of this or any other warranty, expressed or
implied, or upon any other basis of liability whatsoever.
Seller's obligation under this warranty shall not include any transportation charges or costs of installation or any liability for direct,
indirect, or consequential damages or delay.
Seller does not represent that its product may not be compromised or circumvented; that the product will prevent any personal injury or
property loss by burglary, robbery, fire or otherwise; or that the product will in all cases provide adequate warning or protection.
Seller, in no event shall be liable for any direct or indirect damages or any other losses occurred due to any type of tampering, whether
intentional or unintentional such as masking, painting or spraying on the lenses, mirrors or any other part of the detector.
Buyer understands that a properly installed and maintained alarm may only reduce the risk of burglary, robbery or fire without warning,
but is not insurance or a guaranty that such event will not occur or that there will be no personal injury or property loss as a result
thereof.
Consequently seller shall have no liability for any personal injury, property damage or loss based on a claim that the product fails to give
warning. However, if seller is held liable, whether directly or indirectly, for any loss or damage arising under this limited warranty or
otherwise, regardless of cause or origin, seller's maximum liability shall not exceed the purchase price of the product, which shall be
complete and exclusive remedy against seller.
No employee or representative of Seller is authorized to change this warranty in any way or grant any other warranty.
WARNING:
This product should be tested at least once a week.
RTTE Compliance Statement
Hereby, RISCO Ltd. declares that this equipment is in
compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC. For the CE
Declaration of Conformity please refer to our website:
www.riscogroup.com
Contacting RISCO Group
RISCO Group is committed to customer service and product support. You
can contact us through our website www.riscogroup.com or as follows:
United Kingdom
Tel: +44-(0)-161-655-5500
E-mail: [email protected]
China (Shanghai)
Tel: +86-21-52-39-0066
E-mail: [email protected]
Italy
Tel: +39-02-66590054
E-mail: [email protected]
China (Shenzhen)
Tel: +86-755-82789285
E-mail: [email protected]
Spain
Tel: +34-91-490-2133
E-mail: [email protected]
Polonia
Tel: +48-22-500-28-40
E-mail: [email protected]
France
Tel: +33-164-73-28-50
E-mail: [email protected]
Brazil
Tel: +55-11-3661-8767
E-mail: [email protected]
Belgium (Benelux)
Tel: +32-2522-7622
E-mail: [email protected]
Israel
Tel: +972-3-963-7777
E-mail: [email protected]
USA
Tel: +1-631-719-4400
E-mail: [email protected]
Figura 1
: Mounting Bracket
Figura 2
: Remove detector from
Mounting Bracket
Figura 3
: Insert batteries
Specifications are subject to change without prior notice. Should any questions arise please contact your supplier.
© RISCO Group 06/12
5IN1639 B
