‘92H’ Series RTR Brushless EP Racing Boat
Before using this ‘92H’ series model and its radio control system, and to ensure the safety of yourself and others, it is
very important that you read these instructions thoroughly and understand them.
‘92H’ series models are capable of speeds in excess of 85km/h! Care should be taken to avoid the possibility of
injury and/or property damage.
‘92H’ series models are designed for use in fresh water only. They are not designed for use in salt water!
‘92H’ series models are not intended for persons under 14 years of age, unless closely supervised by an adult.
Assemble the included boat stand by slotting the pieces together as shown (X-Blaze stand shown for reference).
Apply cyanoacrylate glue or 2-part epoxy to secure the joints and allow the glue to completely set before placing
your ‘92H’ series model on it.
1) Slide the rudder assembly into its mount and secure with the cap screws and nuts provided using the included
3mm Allen key and a 5.5/7mm spanner. See ‘ADJUSTING THE REAR SHAFT STRUT’ section overleaf for details
of position.
2) Slide the rudder connecting rod through the mount in the rudder arm and secure it using the 3mm Allen Key.
3) Take the silicone cooling tube that exits the right rear side of the hull and push it onto the water inlet nipple on top
of the rudder.
4) Finally, fit a propeller to the propeller shaft and secure with the intended nyloc nut. Do not overtighten as the
nylon insert will prevent the nut from accidentally working loose!
Note: When securing the rudder connecting rod, all radio equipment should be switched ‘ON’ and the steering servo
horn should be vertical (neutral).
IMPORTANT
ASSEMBLING THE BOAT STAND
INSTALLING THE RUDDER AND PROPELLER
2
