RIPLINE Screamin' Water Slide Скачать руководство пользователя страница 2

b4Adventure 4010 Holly Street Unit 16 • Denver Colorado 80216 • 1-844-834-4334 

QUESTIONS?  [email protected] · www.b4adventure.com 303-339-0482 

1. SITE SELECTION AND SET-UP

• SCREAMIN’ WATER SLIDE must be properly setup and installed by an adult. 

• ADULT SUPERVISION REQUIRED AT ALL TIMES.

• Choose a clear runway for the slide on a flat, healthy lawn surface free of depressions or high 

spots. The lawn must be a soft, shock absorbing surface, not a hard packed or high traffic area.

• Do not use on pavement, sidewalks, patios, driveways or other hard surfaces.

• Allow a minimum of 10 feet (3 m) additional runway space before the slide.

• Before set-up, check under and around the slide for sharp objects, rocks, sticks, lawn 

sprinklers or other objects that could cause injury to users or damage the slide.

• Place slide down with inflatable bumper side up. Walk off 10 feet (3 m) away on all sides of the 

slide and make sure the 10-foot area on each side is free from concrete, sidewalks, trees, walls, 

holes, rocks, garden equipment, fences, pools and other sharp objects that could injure users.

• Inspect slide for rips, tears or punctures. Do not use a damaged slide.

• Use repair patches included for small tears and punctures. Clean the damaged area 

thoroughly, press patch firmly over puncture, then wait 30 minutes to inflate. 

• Inflate the two long slide bumpers and half circle splash pool bumper.

• Inflate the launch pad.  Inflate ALL bumpers and launch pad to moderately firm- DO NOT 

OVER INFLATE OR DAMAGE MAY RESULT.            

• Wet the entire slide before connecting hose to slide. Connect hose to spray section.  

• Adjust spray height by using your home faucet/spigot handle.  Spray MUST land on the slide 

section for proper sliding operation and safety. 

• TIP: If side panel rolls over, use a towel to align/adjust your sprayers so that water from the 

sprayers lands on the sliding section. Note: towels under outside of inflatable bumpers only. Do 

not place under the sliding section.                      

2

2. BEFORE EACH USE

• Check your slide for tears, leaks or any signs of damage.  Use the included repair patches for 

small tears and punctures. See instructions on back of patch for directions.

• Too big a tear to repair?  Contact b4Adventure for ordering information:  1-844-834-4334 or 

[email protected].

• Do not add or use other products with the SCREAMIN’ WATER SLIDE as injury may result.

• Review ALL safety instructions with children before letting them use the slide

3. AFTER EACH USE

• Detach garden hose. Carefully deflate the slide bumpers and pad by pinching the valve with 

your fingers.  Tip:  Have a friend work their way towards you while pushing the air from the 

bumpers and pad.

• Clean your slide of any dirt, grass or debris.  Use a mild dish soap solution.  Do not use caustic 

or harsh chemicals as they may damage the slide material. 

• Rinse the slide completely, dry and roll up. Store Slide and Surf water slide indoors or in closed 

container only after the slide is completely dry (to avoid mold/mildew).

• Store slide in a secure place, away from children, to prevent suffocation or unsupervised use.
 

for more detailed information on how to repair your water slide visit:

https://www.b4adventure.com/waterslide-repair/

Отзывы: