4
PCB material board with 3 fixed screws.
1.
Make sure your micro USB cable is ready.
User can adjust micro USB cable to the right channel based on the
location & direction of micro USB port on the smartphone.
2.
Lock PCB material board on the top cover by 3 screws
3.
There are another 3 fixed screws on the PCB material board.
Aiming at fixed screws
put holder on them
pull down and left
for locking
(The transparent acrylic board is for reference only)
1.
The holder is stuck on the top cover by 3 fixed screws.
2.
Put smartphone onto holder. It will use PU glue & suction cup to fix
smartphone. And, user can plug micro USB cable to
smartphone. Then, user can begin to do the BT pairing or wired
connection.
3.
When the pairing is completed, the data you scan will be sent to
smartphone easily.
There are two operating modes on the scanner
1.Data Transmission mode(Default)
It is a necessary to scan “clean memory data” when
switching between these two modes.
Within 2.4GHz radio range
Beyond 2.4GHz radio range
Data
read
Transmit data to
smartphone/tablet directly
Save data in scanner’s memory,
scanner will transmit data to
smartphone/tablet automatically
after getting back to 2.4GHz radio
range.
Enter Data Storage mode
LED
Green/ Orange LED flashes,
followed by 3 beeps.
2. Data Storage mode(Batch Mode)
It is a necessary to scan “clean memory data” when
switching between these two modes.
Data
read
Save data directly to scanner’s memory. It will transmit data to
smartphone/tablet after you scan the Transmit memory data
code. To delete data, please scan the Clean memory data code.
Enter Data Transmission mode
LED
Green/ Orange LED flashes followed by 3 beeps.
Always Clean memory data before switching to Data Transmission
Mode.
Otherwise Red/ Orange LED will flash with one long beep sounds
and will not switch modes.
A.
Data Transmission mode
(Default)
1.
When you are out of BT signal range,
the data you scan will be saved to
memory. Once you are back within
range, the data will be sent to
smartphone/tablet automatically.
B.
Data Storage mode(Batch mode)
1.
Data Storage mode (Batch mode):
When you scan the barcodes, the data
will be saved directly to scanner’s
memory. After you scan the
“Transmit memory data” code
(above right), the data will be sent to
smartphone/tablet.
2.
Before you can continue to scan or
switch modes, you must first delete
the data stored in the memory. To do
this, scan the “Clean memory data”
code. (below right)
Transmit memory data
Green/Orange LED flashes
followed by 3 beeps
The barcode data which is stored
in the memory will be sent to
smartphone/tablet directly.
(under Batch mode, within
Bluetooth service range)
Clean memory data
Green/Orange LED flashes
followed by 3 beeps.
The barcode data which is stored
in the memory will be deleted. You
can then switch modes.
Holder
PCB material board
with 3 fixed screws.
Holder-back side
(for top cover)
Holder-front side
(for smartphone)