3
Notes:
*
This product complies with Bluetooth standards. This device that
communicated with this product must support the same SPP or HID.
For other Bluetooth devices with other profiles we cannot guarantee a
connection before the product has been tested.
*
The communication speed and range of the product may vary due to
obstacles and radio wave condition between the product and device to
which it is connected. Condition on the host device may also affect the
communication speed and range of the scanner.
LED Indicator Information
Orange LED ON
Full charged
Orange LED Flashing
Charging / Low battery
Red LED ON
Offline / out of service
Green LED ON
Good read
Orange LED ON
Good read (Batch mode)
Remark:
*
When the battery power is too low, the Orange LED will flash and
beep once. Scanner should be charged immediately.
*
In case the power consumed out totally; the RTC (Real Time Clock) will
back to original setting 01012000.
*
If scanner shuts down, it is recommended to charge it fully before
turning it on.
*
Under power-saving mode, there will not be LED indication when
charging.
Soft-Keyboard setting code for Android / iOS
For Android
For iOS
*
Under Android system:
If you want to raise/lower On-screen keyboard, please read the
above setting code first. Then, press left button for 2 seconds
to activate it. (LEDis RED /Bluetooth is offline), press it again to
lower keyboard (LED is off/ Bluetooth is online).
*It will take 5~10 seconds to make BT online/offline.
*When BT is offline, scanning function is stopped.
* Under iOS system:
Please read the above setting code first. Then, press left button
for 2 seconds to raise/lower On-screen keyboard;
Reset Configuration to Defaults
(scan from A1 to A4 for HID profile or B1 to B5 for SPP profile)
HID profile
SPP profile
A1
B1
A2
B2
A3
B3
A4
B4
B5
There are two operating modes on the
scanner
1. Direct-scan Mode
1.
select
Direct-scan
2a.
BT connected, begin to
scan the barcodes
MAIN>
H 12:52
Direct-scan
Memory-scan
Upload
↑
ENTER
↓
D>
H 12:52
ESC
SCAN
2b.
BT is disconnected.
D>
H 12:52
Off line !!!
…Linking!
ESC
If BT is disconnected, please back to
page #2 and do the pairing
procedure again.
2. Memory-scan Mode
1.
select
Memory-scan
2.
begin to scan the barcodes
MAIN>
H 12:52
Direct-scan
Memory-scan
Upload
↑
ENTER
↓
M>
H 12:52
ESC
SCAN
Under Memory-scan mode, enable/disable “Quantity
entry” function
Disable “Quantity entry” (default)
1.
disable “Quantity entry”
Setting code
2.
begin the scan the barcodes
M>
H 12:52
ESC
SCAN
3.
press
DEL
to delete the last
barcode data
4.
be sure that you want to
delete the last barcode.
M>
H 12:52
1234567
ESC
SCAN
DEL
M>
H 12:52
The last code
Will be deleted !
Are you sure ?
NO
YES