BEFORE YOU USE THE RV-PRO 360 BY RINNOVISION,
CHECK THE FOLLOWING POINTS:
RECOMMENDED METHOD OF INSPECTION BY RINNOVISION
See our video on
rinnovision.com
Assembly of the RV-Pro 360:
• Screw on the telescopic pole in the superior connector on the RV-Pro 360.
• Make sure the telescopic pole is not over-tightened. Stop screwing when the pole
touches the RV-Pro 360. Do not use excessive force.
• When extending the telescopic pole, note that there is a black marker 20 cm before
the end of each section to warn the operator to slow the descent. This is to make sure
that the section lock can be engaged properly and that the section does not separate
from the rest of the mechanism.
• When using for the first time, make sure the GoPro Max is properly fixed in place
on the tripod.
• When using afterward, make sure the GoPro Max is not loosely screwed onto
the tripod.
Inspection with the RV-Pro 360
• When arriving on site, install all the
mandatory security measures.
• Open the accessing point using all
the mandatory security steps.
• Find the exiting pipe of the accessing point.
This will be used as a reference point;
the reference point will be placed at the
six-o’clock position.
• Place the RV-Pro 360 camera pointing
down, roughly one (1) meter above the
access point. Try to center the camera
for a better result.
• Start recording.
• Start the descent while keeping the
camera center in the access point.
RinnoVision suggests lowering the camera
at a speed of three (3) meters per minute.
• When the camera reaches the bottom of
the access point, stop lowering the camera
before it touches the bottom.
• Pause for three (3) seconds.
• Make a quarter turn clockwise from the
access point.
• Pause for three (3) seconds.
• Start pulling back the RV-Pro 360 while
keeping it centered in the access point.
RinnoVision suggests a speed of three (3)
meters per minute.
• When the camera is back in its starting
position, stop recording.
• Close the access point.
• Clean the RV-Pro 360 and the GoPro Max
with a wet cloth. Do not use cleaning
products containing ammonia.
• Before recharging, make sure that there
is no water in the charging port.
• Make sure you close the charging port
before using the RV-Pro 360 to prevent
water build-up in the connector.
3
USER GUIDELINE
RV-PRO 360 BY RINNOVISION