4
INSTALLATION
En
g
lis
h
h
This appliance can be installed in ducted or recirculation
mode.
Ducted mode
(Fig. 4)
•
In ducted mode, the extractor hood fan extracts the
cooking vapours and passes them through the
grease filter. The air then flows to the outside.
•
The grease filter absorbs the solid particles in the
cooking vapors.
•
In this mode,
only aluminum filters are installed
(charcoal filter is optional)
.
Fig. 4
Connection to exhaust air pipe
(Fig. 6)
•
Attach Ø160mm pipe directly to the air outlet and
secure appropriately (Fig. 6).
•
Connect pipe to the outdoor duct.
Wall mounting
(Fig. 7 & 8)
Do ensure that the appliance is mounted on a solid
surface which could withstand the appliance
’s
weight.
•
Draw a vertical line at the center of the wall.
•
From bench top (see A), draw a horizontal line (see
B) above minimum installation height level.
•
Mark a reference point at C. Repeat this step on the
other side.
•
Drill Ø 8mm holes at center of marking points. Insert
wall plugs in the wall.
•
Fix the hood body to wall using 2(two) ST5 x 25
screws provided. Tighten screws firmly. Note: Adjust
the hood body alignment if necessary (Fig. 9).
•
Place mounting bracket on the wall at desired height
level, aligning bracket center at vertical line (see D).
•
Mark the center of the bracket holes and drill Ø 8mm
holes. Insert wall plugs in the wall. Secure mounting
bracket firmly using 2(two) ST5 x 25 screws provided.
•
Fix the inner duct to both mounting bracket using
2(two) M3 x 12 screws provided (Fig. 8).
•
Slide the outer duct downwards and ensure that it is
well seated on the hood body.
Fig. 6
Fig. 7
