Rinnai Infinity 20 External, Руководство по эксплуатации и установке

Страница: 28 / 44

28
2.7.2 UNIVERSAL WATER CONTROLLER (MC-601) INSTALLATION
1. Determine the most suitable position.
2.
Mark and drill 3 holes (mounting and cable access) for water controller dimensions.
3. When running cable through the access hole ensure the connector end of the cable is located nearest to the
water controller (Fig. 1).
4. Carefully remove the cover plates from the water controller, using a screw driver (Fig. 2).
5. Connect the cable to the water controller. Feed any excess cable lengths into the wall cavity to avoid the
pinching of cables between the wall and the water controller.
6. Fix the water controller to the wall using the appropriate fixings (Fig. 3).
7. Remove protective film from the water controller face and replace the cover plates (Fig. 4).
Additional programming and activation equirements
QUESTION
?
1
Are there four water controllers connected?
IF NO: You have three (or fewer) water controllers, go to Question 2.
IF YES:
You will need to activate the fourth water controller as follows:
STEP 1: For the water controller in the kitchen only, press and hold the ‘Priority transfer’ and
‘On/Off’ buttons simultaneously (see Fig. 1) until a ‘beep’ is heard (approximately
5 seconds).
STEP 2: Check that the display on all four water controllers is lit and displaying a
temperature when ‘switched on’. If any one of the water controller displays two
dashes (see Fig. 2) repeat STEP 1.
This completes the activation procedure for the fourth water controller, you may
ignore Question 2.
QUESTION
?
2
Is the water heater marked to state it delivers water not exceeding 50°C?
IF YES:
No further action required..
IF NO: You will need to program the kitchen water controller to enable selection of
temperatures higher than 50°C.
STEP 1: For the water controller in the kitchen only, press and hold the ‘Priority transfer’
and ‘On/Off’ buttons simultaneously (Fig. 3) until a ‘beep’ is heard (approximately
5 seconds).
STEP 2: When the water controller fitted in the kitchen is switched On, it should be possible
to select temperatures higher than 50°C. If not, repeat STEP 1.
NOTE
If the water controller in the kitchen is replaced, repeat STEP 1 for the replacement water
controller.
If the water controller in the kitchen is swapped with another water controller (for example, the
water controller fitted in a bathroom), repeat STEP 1 for the water controller moved from the
kitchen to the bathroom. Then perform STEP 1 for the water controller moved from bathroom to
the kitchen.
Connector
Controller Cable
Screws
Film
Fig. 1 Fig. 2 Fig. 3 Fig. 4
Cover
Plates
Fig. 1
Fig. 2
Fig. 3