Rinnai INFINITY 16, Руководство по эксплуатации и установке, Страница: 8 / 36

Rinnai 8 HW_CF OIM
MAXIMUM DELIVERY TEMPERATURES
NOTE
This does not apply to “50 degree compliant” models. To meet the regulatory requirements the
maximum delivery temperature is factory set and sealed.
refer to "Table 2. Maximum Delivery Temperatures" on page 31. The appliance model number
can be found on the dataplate, which is located on the left hand side of appliance.
OPERATION WITHOUT WATER CONTROLLERS
Rinnai WATER CONTROLLERS
NOTE
Other manufacturers water controllers are
NOT
compatible with Rinnai water heaters. Rinnai
water controllers brought in from other countries are also
NOT
compatible with Rinnai appliances
sold in Australia.
Water controllers
MUST NOT
be used with any Solar Boost water heater.
Location
Water Resistance
NOTE
Controllers
MUST BE
installed at least 400 mm above the highest part of a sink, basin or bath.
DO NOT
immerse the water controller into water.
AVOID
direct exposure to water or steam as these conditions may cause a malfunction.
ALWAYS AVOID
exposure to water when the battery compartment is open.
When cleaning your water controller use
ONLY
a damp cloth and a mild detergent.
WATER TEMPERATURE CONTROL