Rinnai FC510, Инструкция по установке и эксплуатации

Страница: 19 / 44

Fan Convector Manual 19
Operating the Timer(s) (FC824):
NOTE
Before operating the Timer(s), the clock time must be
correct, and a starting time and finishing time for the
Timer(s) must be programmed. The two Timers
operate in the same way. This heater will begin
operating before the programmed starting time in
order for the room to reach the temperature setting
by the programmed starting time.
1. To select the Timer(s) to commence heating:
Check that the time shown on the Digital Display is
correct. Check the ON and OFF times for both Timers.
2. Press the ON-OFF button to operate the heater:
The On indicator will glow green and the heater will
begin to operate. Select the desired temperature
setting.
3. Press the Timer 1 and On Timer 2 button(s). The
Timer indicator(s) will glow and the heater will remain
on standby until one hour prior to the time
programmed into the selected Timer(s). When this
time is reached, the Timer indicator will flash and the
heater will operate. The ON indicator glows red when
the heater commences operation.
The heater can be operated to alternate between
Timers automatically during cold weather by selecting
Timer 1 and Timer 2 together. Both Timer indicators
will glow. The appliance will remain on standby at
intervals between the programmed finishing and
starting times of each Timer. While the heater is
operating during programmed intervals the Timer
indicator will flash.
NOTE
If there is a power failure, the system memory will
retain the Timer programs and the clock will stop at
when the power goes off. The clock will start keeping
time again when the power returns but will have to be
reset to the correct time.
Override Function:
NOTE
This function is intended to be used to manually
override the current operation of the heater while it is
in Timer mode. For example, if the heater is in standby
(between the end time and start time of the Timer),
and the Override button is pressed, then the heater
will operate and heat the room. If the heater is in
operation in Timer mode, then pressing the Override
button will turn the heater OFF.
To operate the Override simply press the Override
button. The Override indicator will flash.
To manually deactivate the Override simply press the
Override button again. The Override indicator will go
out, and the heater will return to standby mode or
ON mode depending on the programmed times.
NOTE
The heater will continue to operate on Override until
the Override button is pressed again, or one of the
Timers takes over the operation of the appliance. This
means that the Override mode will automatically
drop out if a programmed Starting time is reached.
The appliance will then return to operating at times
programmed into the Timer(s).