Rinnai Australia
21
Energysaver - Operation & Installation Manual
Cleaning
Your heater needs very little maintenance, but the following information will help you to keep it looking
good, and working efficiently.
•
Unplug electrical cord before cleaning.
•
All parts of the heater can be cleaned using a soft, damp cloth and a mild detergent.
•
Do not use solvents to clean any parts.
Fan Filter
To protect the room air fan from dust particles or
lint, a filter is situated at the rear of the appliance.
When this filter becomes blocked, the filter
indicator will flash to indicate that it should be
cleaned. Clean the filter weekly during the heating
season. Dusty filters reduce the air flow through
the appliance reducing heating effectiveness.
•
DO NOT remove filter when appliance is
operating.
•
When the filter requires cleaning, clean filter
before using the appliance, or whilst the
appliance is not operating.
If you do not clean the filter at regular intervals
and the filter indicator
is allowed to remain
flashing, then the appliance will stop and [14]
will flash on the Digital Display signifying that
the inbuilt safety device has functioned. You
must clean the filter before operating the
heater again.
•
DO NOT use the heater with the filter indicator
flashing as this may cause overheating.
•
DO NOT not wait for the filter indicator to flash
before cleaning filters.
Ensure to fit the Fan Filter back in the appliance after cleaning.
DO NOT operate appliance without filter in place.
Regularly check the outside flue terminal to make sure it is clear from plant growth and from other
obstructions. Refer “SAFETY” on page 2 for additional requirements.
Set
Room
on off
Filter
Clock
Timer 1
Timer 2
Child Lock Economy Timer 1 Timer 2 Override
Set Times
ON / OFF
AM
PM
ON
Temp
Time
1
15
Function Lock
Room
AM
PM
Timer 2
Override
Economy
Set
Temp
Time
Timer 1
Set Times
ON / OFF
Clock
Timer 1
Timer 2
1
Filter
ON
15
on
off
15
Remove filter by pulling straight
up and out from appliance.
WARNING
CARE OF YOUR ENERGYSAVER