Rinnai DEPH-10DTW, Руководство по эксплуатации и установке

Страница: 8 / 16

Rinnai 8 DEPH_OIM
HOW TO OPERATE THE HEATER
CONNECTING THE POWER
Plug the heater into a power outlet and turn the power outlet on. Once power is connected the rising start up chime
will sound and the power indicator
will illuminate on the Digital LED display to show the heater is now in
standby mode.
OPERATION
1. Press the POWER button on the control panel console once to start heating operation, a second rising
chime will sound. The two digits on the display panel will now show the programmed temperature setting.
The factory temperature setting for the heater is 21°C. If this is above that of the current room temperature the
red operation indicator
will illuminate and the heater will begin to heat the room.
2. To change the temperature setting press the MODE button once. The °C (temperature) indicator on the
display panel will flash.
Press the ‘Up’ or ‘Down’ buttons to increase or decrease the temperature setting. The available
temperature setting range is from 5°C to 30°C.
3. To exit the temperature setting operation either press the MODE button twice or wait 5 seconds. The
selected temperature will now be set and displayed.
If the selected temperature is above that of the current room temperature the red operation indicator will
illuminate and the heater will begin to heat the room.
If the selected temperature is less than that of the current room temperature the red operation indicator will
go out and the heater will go into a standby state until the room temperature has fallen below the set
temperature, when the heater will then automatically switch on and heat the room.
4. To stop heater operation completely press POWER button , the shutdown falling chime will sound, the power
indicator will remain illuminated to show that the heater has returned to standby mode.
If after 5 seconds no buttons are pressed the °C indicator will stop flashing and the display will
revert back to the current operating setting. Simply press the MODE button
to re-enter
temperature setting operation.
During the initial burning in period or after long periods of non use some light grey smoke or smell
may be experienced. This is normal and is caused by dust that may have settled on the heating
element. During this period the space being heated should be well ventilated.
2
4
1
3
6
5
7
11
B
14
A
6 B
1 A
5
7
2
11
NOTE
2
3 4
2
7
7
1
6
IMPORTANT