Demand Duo
™
H
-
Series Installation and Operation Manual
47
3.
Remove the desired knockout along the
perimeter of the electric box for conduit
installation (Figure 55).
2.
Remove the two screws around the outlet
cover. Remove the outlet cover and
prewired outlet (Figure 54).
4.
Install conduit into the knockout opening
and pull the green, white and black wires
into the box.
5.
Strip the green, white, and black field sup-
plied wires 1/2 in. Make sure the conductors
are completely bare (Figure 56).
6.
Match the wire colors, then grip the wire
firmly and push the conductor into open
port of the push in connector (Figure 57).
1.
Locate the electric conduit on the side of
the water heater (Figure 53).
Use only one conductor per port. Verify
conductor is fully inserted to the back of
the connector.
NOTE
Figure 53
Figure 54
Figure 55
Figure 56
Figure 57
