Rinnai
3
3PH Auxiliary Relay Box OIM
SAFETY AND REGULATORY INFORMATION
WARNING
DO NOT
operate this system before reading the manufacturers instructions.
This appliance must be installed, commissioned and serviced by an authorised person in
accordance with all applicable local rules and regulations.
Access covers of water heating system components will expose 415V wiring and MUST only be
removed by an authorised person.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
For continued safety of this appliance it must be installed, operated and maintained in accordance
with the manufacturer’s instructions.
Children should be supervised to ensure they
DO NOT
play with the appliance.
The power mains must have a circuit breaker and it must be adequate for unit FLA. If the power
supply cord is damaged, it
MUST BE
replaced by an authorised person in order to avoid a
hazard. Take care not to touch the power connections or plugs with wet hands.
Care should be taken not to touch the pipe work as it may be HOT!
DO NOT
place articles on or against this appliance.
DO NOT
store chemicals or flammable materials near this appliance.
DO NOT
operate with collectors or covers removed from this appliance.
DO NOT
activate heat pump unless cylinder is full of water.
NEVER
use a flammable spray such as hair spray, paint, etc near this unit as this may cause a
fire.
At the end of the service life of the heat pump water heater and prior to being disposed of, a
person qualified with refrigerant handling must recover the refrigerant from the system. The
refrigerant must not be vented to atmosphere. Please call our National Help Line to arrange for
an inspection.
WARNING
MANDATORY INSPECTION PRIOR TO INSTALLATION
Immediately report any damage or discrepancies to the Supplier of the appliance. This
appliance was inspected and tested at the time of manufacture and packaging, and released for
transportation without known damage. Upon receipt, inspect the exterior for evidence of rough
handling in shipment. Ensure that the appliance is labelled correctly for the gas and electrical
supply, and/or other services it is intended to be connected to.
For safety and warranty purposes, appliances that may be damaged or incorrect
MUST NOT
be
installed or operated under any circumstances. Installation of damaged or incorrect appliances
may contravene local government regulations. Rinnai disclaims any liability or responsibility
whatsoever in relation to the installation or operation of damaged or incorrect appliances.
NOTICE TO VICTORIAN CONSUMERS
This appliance must be installed by a person licensed with the Victorian Building Authority.
Only a licensed person will have insurance protecting their workmanship.
So make sure you use a licensed person to install this appliance and ask for your Compliance Certificate.
For further information contact the Victorian Building Authority on 1300 815 127
WARNINGS AND IMPORTANT INFORMATION
