Rinnai BRIVIS Touch, Руководство по установке и настройке, Страница: 20 / 24

Rinnai 20 Touch Wi-Fi Kit IM
TOUCH Wi-Fi MODULE NOT SAFELY ACCESSIBLE
The Touch Wi-Fi Module will alternate between its normal and configuration modes of operation when it cannot connect to the Wi-Fi
Router it has been assigned to connect to. As this happens the Touch Wi-Fi Module will report an error code to the Master Networker
Controller to indicate its operating mode.
Look for Error Code 53 at your Master Networker Controller, which access is dependent on the type of controller installed:
•
For an N-C7 Touch type controller, look for the icon being displayed and upon pressing it the following message:
“Networker
fault detected – Code#53”.
•
For an N-C6/N-C3 type controller, upon pressing the Fn1 key sequence look for the following message being scrolled across the
screen:
“Sensor fault – n11 Code#53”
Then follow Step 4 of the Installation and Configuration section to reconfigure your Touch Wi-Fi Module.
NOTE
The Rinnai Touch App will step you through the above process when the Touch Wi-Fi Module not accessible option
is selected.
PWR BUS WiFi SER PWR BUS WiFi SER PWR BUS WiFi SER
Switch Over Switch Over Switch Over Switch Over
Normal Operating Mode
(Searching for assigned Wi-Fi Router)
After 30 seconds of not locating the
Wi-Fi Router Error Code 52 is reported
3 min
Normal Operating Mode
(Searching for assigned Wi-Fi Router)
After 30 seconds of not locating the
Wi-Fi Router Error Code 52 is reported
3 min
Configuration Mode
(Temporary as module already
assigned to a Wi-Fi Router)
Error Code 53 is reported to indicate
configuration mode operation
2 min