Rikon Power Tools 60-200, Инструкция по эксплуатации

Страница: 8 / 16

8
Fig. 08
Fig. 09
Assembly Continued
Threading Band Straps in Filter Bags
1.) Unfold both bags and lay on a flat surface.
2.) Locate the slit on the right side of the top lip of
each bag.
3.) Start the slotted catch end of the band strap
through the right slit (Fig. 09) .
4.) Work the strap around the inside of the bag until it
emerges through the slot on the left side.
Installing Filter Bags to the Collector Housing
Note: If you purchased the optional canister this step can
be omitted for the top bag only.
1.) Slide the filter bag over the collector housing.
2.) Engage the catch end of the strap with the clasp in
the appropriate slot to ensure a tight fit (Fig. 10) .
3.) Press the lever with the palm of your hand to lock
the clamp.
4.) To release the clamp, lift up on the lever. If the
lever is hard to disengage simply use a flat head
screwdriver to pry the lever upwards.
5.) Hang the upper bag from the hook on the upper
bag support .
Mounting the “Y” Inlet
1. Slide the “Y” inlet over the large opening on the fan
housing. Secure with the supplied phillips head screw
(Fig. 11) .
Fig. 10
Fig. 11
Installing the 5” Hose
Locate the 5” hose and two hose clamps.
1. Slip a hose clamp over both ends of the hose
(A--Fig. 08) .
3.) Place one end of the hose over the 5” outlet on
the fan housing and the other end on the collector.
(Fig. 08) .
4.) Tighten the clamps with a slotted screwdriver or
wrench.
A
A