9
ASSEMBLY
COVER
RAILS
INSTALLING THE HANDWHEEL KNOB for Height Setting of the Thickness Table
1. Locate the Handle Screw and Height Adjustment Handwheel.
2. Place the Height Adjustment Handwheel onto the shaft at top corner of the Planer.
3. Tighen the Handle Screw with the supplied 4mm hex wrench. FIG. 1.
FIG. 1
INSTALLING THE DUST PORT
1. From the back of the machine, place the Dust
Hood over the Cutterhead Assembly.
2. Locate the two Dust Hood Knobs (A, Fig.2).
3. Align the Dust Hood over the holes on the top of
the Cutterhead Assembly, and tighten the Dust Hood
Knobs by turning them clockwise.
4. To minimize sawdust accumulation on your
workpiece, attach either a 2-1/2 in. or a 4 in. vacuum
hose to the dust port end.
NOTE:
Make sure all connections are secure and
your dust collector is turned on before any milling of
lumber is done.
FIG. 2
A
A
DUST PORT
