ADJUSTMENTS
REPLACING THE DRIVE BELT
1. Use the supplied 4MM Hex Key to loosen the
screw of the belt guard and then remove the guard
from the rear of the jointer. FIG. 32.
2. Remove the old belt. If the belt is stretched and
loose enough, flex the belt outward while rotating the
upper pulley clockwise to roll the belt off the pulleys.
If the belt is tight and can not be moved off of the
pulley, the belt tension can be released to permit the
removal of the old belt and mounting of the new belt
on the pulleys.
- Loosen the 3 screws (FIG. 33, A), and push the
lower motor pulley (B) upward.
- Remove the old belt, and install the new belt onto
the two pulleys.
- Press down on the lower motor pulley to put
tension back onto the belt, and tighten the 3 screws.
NOTE:
Check the tension with thumb pressure.
The drive belt should not give more than 1/4” in the
center. FIG. 34.
3. Replace the blade guard over the drive belt and
secure it in place with the screw from step 1.
FIG. 33
FIG. 31
FIG. 32
A
B
FIG. 34
A
A
CONTINUED FROM PAGE 17
18
5. Rotate extension leveling cam (A-Fig.31) by
placing a Hex Key in the adjustment hole (B-Fig.31).
6. Once the desired height is achieved tighten the
locking set screw (Fig.30 Page17).
7. Repeat steps 1 through 5 for leveling the infeed
table extension support.
A
B
