4 How to Use
4-4. How to wire
- 17 -
TAN-5000
<Figure of Terminal Plate>
NOTE
Install the buzzer unit in a single-unit case (option) or multi-unit case (option) before using it.
This section explains using the single-unit case.
For information on using the multi-unit case, see the operating manual of the multi-unit case.
*1: A signal to be used between the indicator/alarm unit (option) and the buzzer unit. This may not be used
by the user.
*2: Output only if RS-485 (option) is installed in the indicator/alarm unit.The buzzer unit does not have the
RS-485 function. The input-output from the indicator alarm unit passes through the buzzer unit.
*3: Used for transition wiring for signals between devices when single-unit cases (option) are connected.
When this connector is used, no transition wiring between cases is required at the terminal plate.
Unassigned
Buzzer stop (check)
Signal input (from outside)
Reset signal output(*3)
Unassigned
Buzzer stop (check)
Signal output (*3)
Reset signal input
(from outside)
Common (*3)
First alarm signal input
(*1, *3)
Fault alarm signal input
(*1, *3)
Buzzer signal input
(*1, *3)
Second alarm signal input
(*1, *3)
Unassigned
RS-485
Input-output
(*2, *3)
Power input
24 VDC
Common first alarm
contact output
Common second alarm
contact output
Common fault alarm
contact output
Grounding
terminal
Connector for between
single-unit cases (*3)
Terminal plate
