11
2
7
9
13
10
12
8
LEVELING GLIDE
12
STEPS 6-10
PRE-INSTALLED
WELD NUTS
STEP 8:
INSERT (2) END CAPS
11
INTO THE ENDS OF THE CROSS SUPPORT
8
.
STEP 9:
ATTACH THE LEG ASSEMBLIES
2
AND
7
TO THE WORKSURFACE
1
USING (16) WOOD SCREWS
12
.
DO NOT OVER-TIGHTEN THE SCREWS. USE A LOW TORQUE SETTING ON THE DRIVER.
STEP 10:
CENTER THE U-CHANNEL
13
ON THE HEX ROD
7
AND BETWEEN THE LEG ASSEMBLIES
2
AND
7
.
DO NOT USE ANY PILOT HOLES. ATTACH THE U-CHANNEL WITH (8-12 ) WOOD SCREWS
12
.
STEP 11:
WITH THE HELP OF AN ASSISTANT, SET THE WORKSTATION UPRIGHT IN ITS FINAL LOCATION. LEVEL THE
WORKSTATION IF REQUIRED BY TURNING THE LEVELING GLIDES CLOCKWISE (FROM THE TOP) ON THE LOW
CORNERS OF THE UNIT. IF YOUR WORKSTATION HAS CASTERS, LEVEL IT BY TURNING THE BOLTS ON THE TOP OF
THE CASTERS. THE WORKSTATION IS NOW READY FOR USE.
4.000
6703 ZINSER ST., SCHOFIELD, WI 54476
PHONE: 800.298.4351 FAX: 866.882.9475
www.raproducts.com
K&A MANUFACTURING
STEP 5
1
6
B
PAGE 2 OF 3
DETAIL B
.
STEP 5:
INSERT THE HEX ROD
6
INTO THE HEX DRIVE NEAR THE TOP OF THE LEG ASSEMBLY WITH THE CRANK
ASSEMBLY ATTACHED. PLACE THE OTHER LEG ASSEMBLY ON THE WORKSURFACE INSERTING THE OTHER END OF
THE HEX ROD INTO THE HEX DRIVE.
STEP 6:
WITH THE HELP OF AN ASSISTANT, PLACE (4) WASHERS
9
ON (4) SOCKET SCREWS
10
. INSERT THESE
THROUGH THE HOLES AT THE ENDS OF THE CROSS SUPPORT
9
AND THREAD THEM INTO THE WELD NUTS PRE-
INSTALLED IN THE LEG ASSEMBLIES. SEE DETAIL B. DO NOT FULLY TIGHTEN.
STEP 7:
LEVEL THE CROSS SUPPORT
8
AT 4" FROM THE BOTTOM OF THE WORKSURFACE SUPPORT. SEE
DETAIL C. FULLY TIGHTEN THE SOCKET SCREWS
10
DETAIL C
