2.
Make sure User Preferences are set for Barcode or Barcode Comments.
Then start Auto Mode.
3.
When the connection is made, the Bluetooth icon will appear and the
light on the scanner will go off
4.
Press the trigger to scan a barcode. The scanner will beep when it detects
a good barcode.
Turn off
1.
The scanner will turn itself off automatically if not used for 10 minutes
2.
Or it can be turned into low power mode by pressing and holding the
trigger for at least 8 seconds. (Note that in this case you can press the
trigger and the laser will scan, but the scanner will not make a Bluetooth
connection until it has been turned on again as above)
For initial configuration, scan through steps 1 to 9 below:
Registered office: Seaward Electronic Ltd, 15-18 Bracken Hill, South West Industrial Estate, Peterlee, SR8 2SW, United Kingdom.
Registered in England No: 01674384 | VAT REG: GB314 1089 92
rigelmedical.com