8
WARNING
Battery Box
To prevent inadvertent
operation of the
up/down switch when the E-Pacer is not
in use, press the E-Stop button (A) to
disconnect the battery.
The battery box houses the microprocessor
and rechargeable battery which power and
control the E-Pacer’s electric actuator.
Up/down arrows (B) on the battery box
control the E-Pacer’s vertical movement
(see Figure 9a).
To insert the battery, slide it into the
battery box, then push the battery back
until it clicks into place. To remove it,
squeeze the lever on the back and lift it out
(see Figure 9b).
To prevent long-term
battery damage, remove
the battery from the battery box and place
it in the charger every night, even if the
battery level indicator is still green.
Battery level indicator
To prevent injury:
• Charge or change the battery
immediately if the battery level light
turns red; do not attempt further lifts
or transfers with a red light.
• Prior to every use of the E-Pacer,
activate the up/down button to turn on
the battery level light, and verify that
the light is green. If it is not, change or
charge the battery.
The battery level light indicates the charge
remaining in the battery (see Figure 9c).
A green light means the charge level is
adequate for use, yellow indicates that the
battery should be charged soon, and red
indicates a very low charge. An audible
beep indicates that the battery is entirely
depleted. A fully charged battery will give
approximately 70 complete lift cycles.
NOTICE
Figure 9a
Figure 9b
Figure 9c
CAUTION
A
A
B
B
