• Line is attached by crimping through shark fin tab or
rear of shaft depending on model purchased.
• Make sure power bands are on top of spearshaft and
shooting line is underneath power bands.
• Place line underneath line plate coming over to top
of spearshaft to groove in the gunstock on right side of
muzzle. Run line down gunstock around line release,
then up to line anchor, and back down to line release.
Use one hand to stretch bungee and put remaining loop
of line around the line release. 3 & 4 line wraps are not
recommended.
• After line is rigged, load power bands.
Types of Line Setups
Standard single wrap
Standard double wrap
Reel
Euro breakaway
Standard breakaway
Floatlines, floats and other accessories may be added to
setup. See website for details.
• Take first power band closest to you in one hand, plac-
ing other hand at butt of the speargun. Pull and swing
into upper stomach area.
• Take both hands and pull power band (closest to front)
to the first tab. The second power band should be loaded
on the second tab & third.
• Two bands can be loaded per large tab; One band per
mini tab.
• Spearshaft with rest tab: Place butt end on hip to load
the power band to the rest tab. After loading to rest tab,
raise speargun by the power band to high stomach area
and finish loading to other tab(s). The rest tab is for ease
of loading and short shots.
• Make sure all power bands are put on speargun the
same way.
Line Rigging
Power Bands Loading
**Complete line rigging and power band loading videos
available online at www.speargun.com
