11
GENERALE
b)
EXEMPTIONS
: The following equipment is exempt from 248 CRM
5.08(2)(a) 1 through 4:
− The equipment listed in Section 10 entitled “Equipment Not
Required To Be Vented” in the most current edition of NFPA
54 as adopted by the board;
− Product Approved side wall horizontally vented gas fueled
equipment installed in a room or structure separate from
the dwelling, building or structure used in whole or in part
for residential purposes.
c)
MANUFACTURERS REQUIREMENTS - GAS EQUIPMENT VENTING SY-
STEM REQUIRED
: When the manufacturer of Product Approved side
wall horizontally mounted gas equipment provides a venting sy-
stem design or venting system components with the equipment,
the instructions provided by the manufacturer for the installation
of the equipment and venting shall include:
− Detailed instructions for the installation of the venting sy-
stem or the venting system components;
− A complete parts list for the venting system design or ven-
ting system.
d)
MANUFACTURERS REQUIREMENTS - GAS EQUIPMENT VENTING SY-
STEM NOT PROVIDED
: When the manufacturer of Product Approved
side wall horizontally vented gas fueled equipment does not pro-
vide the parts for the venting of flue gases, but identifies “special
venting systems”, the following requirements shall be satisfied by
the manufacturer:
− The referenced “special venting systems” shall be included
with the appliance or equipment installation instructions;
− The “special venting systems” shall be Product Approved by
the Board and the instructions for that system shall include
a parts list and detailed installation instructions.
e)
A copy of all instructions for all Product Approved side wall ho-
rizontally vented gas fueled equipment, all venting instructions,
all parts lists for venting instructions and/or venting design in-
structions shall remain with the appliance or equipment at the
completion of the installation.
1.10
Combustibili idonei
Permissible fuels
− Natural gas from the public gas supply in accordance with
national regulations with a total sulphur content < 15ppm.
− LP in accordance with national regulations with a content
of elementary sulphur < 1.5 ppm and volatile sulphur < 50
ppm.
− Ultra Low Sulphur Diesel in accordance with national regu-
lations with a content of elementary sulphur < 15 ppm (for
use as back-up fuel in condensing operation).
− Heating oil type 2 when boiler return temperature is not
lower than 140 degrees Fahrenheit; non-condensing ope-
ration (for use as backup fuel only). See the warranty state-
ment for additional details.
9
Do not use gasoline, crankcase drainings, or any oil contai-
ning gasoline.
− The boiler must only be operated with the specified fuels.
− Only burners that are suitable for the specified fuels may
be used.
− Observe the manufacturer's burner selection list and the
burner manufacturer's instructions.
1.11
Bruciatori
Follow the burner manufacturer’s instructions when fitting the
burner. A pre-drilled burner plate is included with the boiler.
An accessory plate may be required if a non-standard burner is
used (see table).
As standard, the burner plate gasket must be trimmed in order to
fit the burner blast tube.
The installer must cut the hole 3/8" larger than the blast tube dia-
meter.
The combustion chamber door must be opened to allow the bur-
ner to be mounted.
If the burner head is too long to open/close the combustion
chamber door, the burner have to be removed before to open/
close the door.
For reduction of burner capacity according to altitude make refe-
rence to the burner manual.
9
When you finish installing the burner, fill the gap between the
burner tube and the refractory material in the door with the
ceramic insulation supplied loose with the boiler.
RTC 3000
RTC 4000
RTC 5000
Fireside
pressure
drop
inch
W.C.
2.088
2.931
3.011
mbar
5.2
7.3
7.5
RTC 6000
RTC 8000
RTC 10000
Fireside
pressure
drop
inch
W.C.
3.533
3.693
4.777
mbar
8.8
9.2
11.9
At maximum output with water temps supply/return of 176/140 °F
(80/60 °C) and CO2=9.7%.
1.11.1
Bruciatori consigliati per l'abbinamento
BRUCIATORI
BOILERS
MODELLO
RTC
3000
RTC
4000
RTC
5000
RTC
6000
RTC
8000
RTC
10000
GAS
RS100/M
x
●
x
RS130/M
●
x
RS190/M
●
x
●
RS100/E
x
●
x
RS130/E
●
x
RS190/E
●
x
●
RS280/E
●
x
●
x
RS300/E
●
x
●
x
RS310/E
●
RS400/E
●
RS100/EV
x
●
x
RS130/EV
●
x
RS190/EV
●
x
●
RS280/EV
●
x
●
x
RS300/EV
●
x
●
x
RS310/EV
●
RS400/EV
●
RS68/E
x
Содержание RTC Series
Страница 51: ...51...
