20036952
22
GB
Installation
4.9
Electrode position
4.10 Burner refitting
Refit the burner to the slide bars 3)(Fig. 18) at approximately
4” from the sleeve 4) - burner positioned as shown in (Fig. 11,
page 19) - insert the ignition electrode cables.
Remove the extension bars 31)(Fig. 1, page 9).
Slide the burner up to the sleeve so that it is positioned as
shown in Fig. 18;
refit screws 2)(Fig. 18) on slide bars 3) including the safety
plate 15)(Fig. 11, page 19);
secure the burner to the sleeve by tightening screws 1);
connect the oil pipes again by screwing on the two
connectors 6)(Fig. 11, page 19).
connect the swivel coupling 7) from the graduate sector.
WARNING
Make sure that the electrodes are positioned as
shown in Fig. 17.
5/ 32" to 3/ 16"
3/ 32"
Fig. 17
D10108
WARNING
When fitting the burner on the two slide bars, it is
advisable to gently draw out the high tension cables
until they are slightly stretched.
2
3
1
4
5
6
7
Fig. 18
D11171
