Maintenance
37
20019893
GB
6.4
Closing the burner
To close the burner proceed sa follows:
➤
push the burner 16)(Fig. 47) at approximately 4” from the elec-
trical board 17);
➤
insert the ignition electrode cables and then slide the burner
up to the sleeve.
➤
Disinstall and arrange in the correct site the extention bars 7);
➤
refit screws 5) on slide bars 6);
➤
secure the burner to the sleeve by tightening screw 10);
➤
connect the tie rod 8) to the spacer 9);
➤
reconnect the oil pipes 3).
WARNING
When fitting the burner on the two slide bars, it is
advisable to gently draw out the high tension cables
until they are slightly stretched.
After carrying out maintenance, cleaning or check-
ing operations, reassemble the hood and all the
safety and protection devices of the burner.
