7
HANDLING AND TRANSPORT
Handling must be done by properly equipped personnel.
Unit types 15-18 are packaged in a cardboard box with a wooden base.
Raise the box with a fork-lift truck by inserting the forks in the special
guides hollowed out in the support beams.
All units are packaged in a cardboard box with handles for handling.
WARNING!!!
Do not move the heater by holding it by the fins or by the fan motor.
Shipping and handling must be carried out with extreme care, so as to avoid damage to the unit and danger
to the people involved.
During transportation and handling, it is forbidden to stand near the unit.
Use forklift forks with a minimum length equal to the width of the machine.
Should it be necessary to place more than one unit on top of each other, observe the index indicated on
the packaging itself and be very careful when aligning the packages so as not to create unstable stacks.
If the device needs to be moved by hand, make sure that there is enough workforce available in proportion
with the weigh indicated in the section "DIMENSIONS AND WEIGHT" and depending on the distance to
cover.
We suggest using protection gloves.
REMOVING THE PACKAGING
To remove the packaging proceed as follows:
Cut the strap (types 7
9 only);
Open the upper part of the case;
Remove the inner spacers;
Pull the unit upwards out of the case.
Do not dump packaging improperly as it is a potential source of
danger. For proper disposal contact your local authorities.
