21
ASSEMBLY
Fig. 16
Fig. 17
Fig. 18
UNLOCK
PEDAL
CENTER U-BOLT WITHIN THE LATCH MECHANISM
HEIGHT
ADJUSTING
HANDWHEEL
BEVEL
ADJUSTING
HANDWHEEL
LOCK
TUBE
BLADE
HEIGHT
LOCK KNOB
PAN HEAD
SCREW
(1/4-20 x 5/8 in.)
To assemble the Herc-U-Lift™ to the leg stand:
Install the four leg brackets on the inside of each leg using
head screws (1/4-20 x 1/2 in.) and lock nuts (1/4-20).
Tighten securely.
Place the lower section under the leg stand with the ends
of the tube under the front leg brackets. Place a screw
with washer (1/4-20 x 1-5/8) through the leg bracket and
the end of the tube of the lower section. Secure in place
using lock nuts (1/4-20).
NOTE: The screw should freely pivot.
Repeat above step for the upper section of the Herc-U-
Lift™.
Check to insure the upper and lower sections are centered.
If required, loosen frame hardware and adjust the frames
side to side to center. Retighten all hardware.
Press down on the unlock pedal to check alignment of
the U-bolt. The U-bolt should be centered within the latch
mechanism as shown in figure 16. Release the unlock
pedal and adjust the U-bolt as necessary. Retighten all
hardware.
NOTE: With the tool on a level surface, check to make sure
the tool does not move. If tool moves, adjust all four leveling
feet supporting the tool.
TO INSTALL BEVEL ADJUSTING HAND-
WHEEL
See Figure 17.
Locate the following parts:
1 bevel handwheel
1 pan head screw (1/4-20 x 5/8 in. with washer)
Push bevel handwheel onto the bevel shaft aligning
flats on the bevel shaft with the flats on the bevel
handwheel.
Secure in place using the screw (1/4-20 x 5/8 in. with
washer).
TO INSTALL HEIGHT ADJUSTING HAND-
WHEEL
See Figure 18.
Remove blade height lock knob by turning the knob
counterclockwise.
Slide the height adjusting handwheel onto the rod and
against the lock tube.
Secure the height adjustment handwheel by reinstalling
the blade height lock knob.
U-BOLT
LATCH
MECHANISM
