RIDGID SeeSnake nanoReel, Быстрый старт

Страница: 4 / 16

4
–
English
SeeSnake nanoReel Quick Start Guide
Troubleshooting
Problem Probable Fault Location Solution
Camera image
not seen
No power to SeeSnake
CCU or micro CA-300
camera monitor connector
Check power cord is correctly
plugged in.
Check the switch on monitor/
display unit.
Connections faulty
Check alignment and pins of
connection to nanoReel system
unit from CCU or display unit.
Check orientation, seating, and
pin condition in the SeeSnake
connection.
Monitor set to wrong
source
Set video source as described in
display unit
operator’s manual.
Batteries low Recharge or replace batteries.
“SOS” code
blinking on LCD*
No video signal
Check source setting of monitor
and
re seat cable connection.
* The light on the LCD will only blink the “SOS” code on some SeeSnake CCUs.