5
Installation Procedure
WARNING: For your own safety,
never connect plug to power source
outlet until all assembly steps are
complete and you have read and
understood the safety and operation
instructions. Do not operate filter
system with any parts damaged or
missing.
1. Select location for Airborne Filtration
System. Unit should be installed with
the side opposite the switch and light
a minimum distance of six inches to
the nearest wall. Ends should be at
least two feet clear of wall surface to
allow for proper air circulation as
shown below.
It is important that you select the loca-
tion carefully so that it is not in a high
traffic area, or consider installing it
above a bench to reduce the hazard of
bumping your head on the unit. The
minimum height required for the unit
and suspension will be 17-3/8", so
keep this in mind when selecting a
location.
2. Joists are normally sixteen inches
apart. Spacing of holes on width of
unit is 19-7/16", and on length of unit
is 26" on center as shown. Chain
allows for suspension from joist in
either direction.
3. Unit weighs 40 pounds so suspension
should be from center of ceiling joists
only.
WARNING: To reduce the risk of
injury from a falling unit, install in
structure that will support 160
pound load.
4. When you have selected the location
for your unit, use a pencil to mark the
four suspension points in the joists
(again, make sure that these points are
at the center of the joists). Drill 1/8"
diameter pilot holes 1-1/4" deep into
each of the four suspension points.
5. Install the four screw hooks in the pilot
holes up to the start of the curve as
shown on page 6.
Wall
Surface
* 24" minimum clearance from wall to
unit openings, 6" minimum from wall
to side.
*6"
32"o/c
26"o/c
*24"
19
-7/1
6"o/
c
*24"
Ceiling Joist
Unit
Suspension
Points (4)
* Minimum
Clearance
Switch & Light Location
Filter Unit
16"
o/c
16"o/c
16"o/c
Ceiling Joist
