4
Operation
1. Set up the stand by extending both legs
to their full outward position. Loosen
height adjustment knob, and adjust the
height of table to support the work-
piece. Tighten knob firmly. Remove
locking pin.
WARNING: To reduce the risk of
injury
from
unexpected
tool
movement, check to make sure
work support does not rock,
slide or move prior to use.
2. Instructions for outfeed support - pivot
position:
a. Rotate the table so that the arrows
printed on the table are pointing up.
b. Align the stand so that the outfeed
arrows match the outfeed direction
of the workpiece. Place the stand
at the distance from the tool so that
the workpiece is supported during
the cut.
c. Place the locking pin in the upper
hole in the table flange. This will pre-
vent the pivoting table from rotating
too far, when pushing a workpiece
off the back of the stand.
3. Instructions for lateral support - hori-
zontal lock:
a. Rotate the table until it is horizontal.
Place the locking pin in the lower
hole in the table flange.
b. Place the stand at the distance from
the tool so that the workpiece is sup-
ported during the cut.
4. For storage, rotate the table so that the
arrows printed on the table are pointing
down. Place locking pin in the lower
hole in the table flange.
Outfeed Direction
Pin
Pin
Pin
© 2001 Emerson
Form No. SP6460
Printed in Thailand 11/01
QUESTIONS OR COMMENTS?
CALL 1-800-4-RIDGID
