4.
Hold the chain saw firmly on the ground with left hand on the front handle
(5)
.
Your thumb and fingers shall grasp the handle.
5.
Place the right foot onto the rear hand safeguard
(12)
and step down.
6.
Pull the recoil starter handle
(26)
lightly until you feel resistance then pull it
rapidly (Fig. 23, step 4). Do it again until the engine starts.
WARNING! Allow the rope to return slowly and in a controlled
manner after each pull! Do not pull out the recoil starter beyond the
red color band at the end of the recoil starter!
7.
Carefully pull the front hand guard
(6)
back toward the front handle
(5)
(Fig.
23, step 5).
8.
Hold the product with the left hand on front handle
(5)
and the right hand on
rear handle
(1)
.
9.
Press the throttle interlock
(2)
and then squeeze throttle trigger
(3)
(Fig. 23,
step 6). The saw chain runs.
Fig. 23
NOTE: If the engine does not start, the engine may be flooded.
Flooding is caused by too much fuel mixture applied at the wrong
time and can prevent a product from starting. Follow below
6
7
22
21
5
26
12
6
5
2
3
36
For Customer Service:
Please call 877-713-3189 (Toll Free), or email: [email protected]
